» » »

Welding Equipment Essentials Mesa AZ

Preventative maintenance is the key to getting the most out of your equipment investment. Like the other gear your metal techs use on a daily basis, your welding and plasma-cutting equipment benefits from a regular maintenance program.

DIY Performance Automotive
(480) 779-9966
1600 W Main St Suite J
Mesa, AZ
Bridwell Automotive Center
(480) 648-1987
7171 E Lincoln Dr
Scottsdale, AZ
Early's Automotive Services
(480) 474-4027, 001-2004
3045 East Main Street, Suite 103
Mesa, AZ
Thompson's Auto Repair & Towing
(480) 833-1071, 001-2004
1325 East Main Street
Mesa, AZ
North Mesa Auto Service
(480) 964-9239, 001-2004
636 North Country Club Drive
Mesa, AZ
Automotive Diagnostic Specialties
(480) 779-7926
6835 W Chandler Blvd
Chandler, AZ
Hi-Tech Car Care
(602) 688-7875
2924 E Thomas Road
Phoenix, AZ
Safelite Auto Glass
(888) 820-2558
2345 E Main St Lot 114
Mesa, AZ
Safelite Auto Glass
(888) 820-2558
25 W Pepper Pl
Mesa, AZ
Safelite Auto Glass
(888) 820-2558
255 E Southern Ave
Mesa, AZ
Data Provided by:
 

Welding Equipment Essentials

If you expect your welding equipment to last longer and perform better, preventative maintenance is a must.

10/1/2001

Preventative maintenance is the key to getting the most out of your equipment investment. Like the other gear your metal techs use on a daily basis, your welding and plasma-cutting equipment benefits from a regular maintenance program. To work efficiently, each type of welding unit has specific requirements. Here's a quick checklist:

Plasma Cutters

  • Plasma cutters need an unrestricted flow of clean, dry air to the torch, so be sure to change the regulator/moisture trap filter on a regular basis.
  • Inspect the torch cable periodically to make sure all connections are tight and that the cable the air flows through hasn't been crushed or damaged.
  • Change the consumables in the torch when they're damaged or worn out.

TIG Welders

  • If you have a water-cooled TIG torch, be sure you're using the correct torch coolant. It's also important to change the coolant based on the manufacturer's recommended schedule.
  • Check for coolant leaks. Leaks at the torch require immediate attention to reduce the potential for electric shock.
  • If your TIG welder has a high-frequency start, watch for erratic performance from the high-frequency feature. When was the last time you checked the gap on the high-frequency points? Check the operator's manual for your specific welder, but remember that this service is best performed by a qualified repairer.

MIG Welde...

Click here to read the rest of the article at BodyShop Business

BodyShop Business is
a Babcox publication
3550 Embassy Parkway
Akron, OH 44333
330-670-1234 • (FAX) 330-670-0874
Advertise      Contact Us      Subscribe      Article Index      Privacy/Terms of Use